Faucet holes
A sink takes 0, 1 or 3 faucet holes, each 1⅜" / 35 mm. With three holes, the spacing runs from 6 to 18 in and is set at 8 in unless you choose otherwise. On a sink shorter than 24 in, the widest spacing is smaller; the configurator shows the limit for your length.
Holes are drilled once, so they match the faucet you send us. If you are unsure, send us the faucet spec sheet and we will check it.
Where the holes go, by form
| Form | Faucet holes | Holes drilled in | Mount |
|---|---|---|---|
| Plinth | 0 | No faucet holes | Counter or wall |
| Ledge | 0, 1 or 3 | The deck | Wall or counter |
| Arch | 0, 1 or 3 | The backsplash | Wall |
| Step | 0, 1 or 3 | The backsplash | Wall |
| Tower | 0 | No faucet holes | Wall or counter |
Ledge takes the faucet on its deck, beside the basin. Arch and Step take it on the backsplash. Plinth and Tower have no faucet holes.
The drain
The drain opening is 1¾" / 45 mm, drilled in the center or at the rear. The size fits a standard pop-up drain, so you can buy the fitting locally. The basins have no overflow, so use a pop-up drain without an overflow hole. The faucet and the drain fitting are not included.
Next
- Configure a sink and choose its holes and drain.
- Install guide: the wall, the bracket and the sealant.
- Sizes and weights.